![toad diagnostic software srs toad diagnostic software srs](https://obd2pros.com/wp-content/uploads/2018/09/Total-Car-Diagnostics.jpg)
If MAIN BODY is not displayed on the BUS CHECK screen on the intelligent tester, proceed to Main Body ECU Communication Stop Mode. The main body ECU is connected to the CAN communication system but CAN communication DTCs are not output. DTC communication uses the CAN communication system. Control Module Communication Bus OFF Control Module Communication Bus OFF DTC communication uses the CAN communication system.
#TOAD DIAGNOSTIC SOFTWARE SRS HOW TO#
Perform troubleshooting according to HOW TO PROCEED WITH TROUBLESHOOTING (See page CA-9). If CAN communication system DTCs are output, trouble cannot be determined solely from the DTCs. In the CAN communication system, CAN communication system DTCs output by the ECU can be displayed by using the intelligent tester. Each of the front and rear rotors has 48 serrations. These signals are used for control of the ABS system. The speed sensor detects wheel speed and transmits the appropriate signals to the skid control ECU. CAN communication system CAN communication system (Skid control ECU to ECM) CAN communication system (Skid control ECU to yaw rate and acceleration sensor) CAN communication system (Skid control ECU to steering angle sensor) In some cases, the intelligent tester cannot be used when the VSC warning light remains on. Engine Control System Malfunction Engine control system 4. Control Module Communication Bus OFF CAN communication system CAN communication system (Skid control ECU to yaw rate and acceleration sensor) In some cases, the intelligent tester cannot be used when the ABS warning light remains on. For details of each code, refer to the See page in the DTC chart. If a DTC is displayed during the DTC check, check the circuit indicated by the DTC.
![toad diagnostic software srs toad diagnostic software srs](https://www.mycarly.com/wp-content/uploads/2021/05/diagnosesoftware-hier-findet-ihr-alles-was-ihr-wissen-musst-2.jpeg)
Reconnect right-side head impact air bag module connector. If DTC 81-B1162 is displayed, replace air bag sensor assembly. If DTC 81-B1162 is not displayed, go to next step.
![toad diagnostic software srs toad diagnostic software srs](https://obdplanet.com/wp-content/uploads/2021/01/71zqepeDSuL._AC_SL1500_-1024x1024.jpg)
Connect jumper wire between Yellow-Violet wire (circuit ICR+) and Yellow-Orange wire (circuit ICR-) of air bag sensor assembly side of right-side head impact air bag module squib harness connector. Reconnect air bag sensor assembly connector A21 (right connector) to air bag sensor assembly.